Envoy NT9010A Guide d'installation télécharger pdf (Page 17)

Section 1.2: Installing The NT9010

1.2.9 Deleting

Wireless

Devices

To remove a wireless device from the system, you will need to use the advanced

programming sections.

1. Press [✱][8], then enter the Installer’s code. The default Installer’s code is [5555].

3. When prompted, press [2] to go to advanced programming.

4. Enter [804], then enter the 2-digit number of the zone you want to delete (01 -

32). The system announces the current serial number for the zone.

5. Program the serial number for the zone as [000000]. The wireless device for the

zone will be removed.

NOTE: You may need to remove power from the system and then restore it

to clear troubles caused by deleted zones.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

Pas de commentaire

Envoy NT9010A Guide d'installation Page 17