Envoy NT9010A Guide de l'utilisateur télécharger pdf (Page 17)

Turning Your System On (Arming) and Off (Disarming)

NOTE: Pressing will only turn on the system. To turn the system off,

you must enter a valid [access code]. See Turning Off Your System on page

10.

Turing On

Your System

with No Entry

Time

If you want to turn on the system, and no one else will be entering, you can

remove the entry time from zones that normally have one. If somebody enters

through any zone, the system will sound an instant alarm.

1. Check that your system is ready (green Ready light is ON)

2. Press , then your [access code].

• The red (Armed) light flashes as a reminder that the system is on and has

no entry time.

• The keypad sounds fast beeps.

3. The system is now in Stay mode.

Tur ning On

Your System

Automatically

(Automatic

Arming)

Your installer may have set up your system to turn on at a pre-set time. If auto-

matic arming has been set up, when the system reaches the pre-set autoarm time,

the keypad buzzers will sound for one minute.

During this one-minute warning time, you may be able to stop automatic arming

by entering your [access code]. Ask your installer for more information.

Your installer may have set up the system so that users with a master code can

change the autoarm time at the keypad. If so, master users will be able to turn the

automatic arming function on or off, and program the time at which the system

will automatically turn on each day.

To turn automatic arming on or off:

1. Press , then [master code].

2. Press to turn automatic arming on or off. The keypad will beep 3 times

when auto-arm is turned ON, and once when it is turned OFF.

3. When you are finished, press .

To change the autoarm time:

1. Press , then [master code].

2. Press .

3. Enter the autoarm time using the 24Hr format (0000 - 2359). For example, to

set the time for 1:00pm, enter (1300).

5. When you are finished, press twice.

NOTE: The system must have the correct time and date in order for the

autoarm feature to work. Please seeSetting the Time and Date on page 21.



1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Envoy NT9010A Guide de l'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Envoy NT9010A